NG06 / Cetop 3 Automatic Reciprocating Valve
AD3I.P.00.1
This valve type is characterised by fully hydraulic operation, as it takes advantage of the system pressure rise to cause an automatic and continuous inversion of the utilization. The change over takes place when the system pressure exceeds the inversion values calibration pressure, and therefore also in not predetermined positions. At cylinder stroke end, the overall maximum pressure valve should be adjusted on a value 30% higher than the system operating pressure.
The inverter valves pressure calibration values should be 15% lower than that of the overall maximum pressure valve, and 15% higher than the maximum operating pressure.
Note: to operate the push button emergency, a minimum pressure of 3 bar on the actuator is needed.